full floating rear axles from just about anything

C

Cummins Land-Rover

Guest
I need a pair of full floating rears from just about anything - Ford Corp, Dana 60, 14 bolt, etc. I want to build a trailer and want to use the hubs. The ring and pinion/center diff section can be shot, all I need is the wheel hubs, or I cna hand all this stuff (including the axle shafts) back to you.

Before I head up to Kinney's, anyone have anything? Ideally both axles would be the same.

Thanks!
 
C

Cummins Land-Rover

Guest
Electric brakes (long story but it can be done).

No, a Dana 30 most definitely won't work :)
 
D

Dirk

Guest
JL, I have a few of these. Was going to build a trailer on them myself....anyway, what do want to pay? :)
 
C

Cummins Land-Rover

Guest
Pay? You expect me to pay? :baby:

Dirk what are they? Ford? I was hoping to be able to drag a pair of them out of Kinney's for about two bills. Last time I was there I could buy old Eatons for about $150, I figure an old Dodge or Ford fan rear end wouldn't be worth more than a hundred bucks but I don't know for sure.
 
D

Dirk

Guest
Not certain about WMS on any of them, some were singles, some dually....
I know there is one 60 and a 14 bolt. have another 14 bolt in a van.
 
C

Cummins Land-Rover

Guest
WMS does not matter. I am cutting the axle tubes down and welding the spindles to some 3.5" Sched 80 pipe after I machine them. I was hoping to stay with Dana or Ford as they have 12 inch drums, the 14 bolt stuff has 13" drums and no one makes electric brakes for 13" drums. What woudl that D60 be worth? What vintage is it? There is a guy selling a D60 on Kijiji, maybe I could get a pair that way.
 
C

Cummins Land-Rover

Guest
Duh, you have two in your FS thread! I should have looked, what's missing on them? If it is diff stuff or brake stuff I don't really care, I need drums though.
 
You must log in or register to reply here.
Top