Made this to help install the heavy large axles, couple of car jacks welded to some 2x2 tube with wheels. C/W Brackets to hold the axle at the right pinion angle.
Just put a angle gauge on the flat part where the stock leaf spring goes (cast part by the pumpkin) and set it to 0 deg.
With the axle truss on, I do not have access to the spring perch anymore. But if it is 0 degrees. I will figure something else out to set it, top of the kingpin cap maybe?
Sexy Christmas purchase!
Where did you pick up the BTF hydro mount?
Nice ring gear... no pinion :stir: